No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Associating IGMP Proxy with NQA

(Optional) Associating IGMP Proxy with NQA

Context

Internet Group Management Protocol (IGMP) proxy lacks a fault detection mechanism to trigger link switchover quickly. Therefore, multicast services may be interrupted for a long time when a link failure occurs. You can solve this problem by associating IGMP proxy with a network quality analysis (NQA) test instance.

After IGMP proxy is associated with an NQA test instance, it can use the NQA test instance to monitor end-to-end link status. When the NQA test instance detects a link failure on the upstream interface, the device configured with the IGMP proxy backup function can switch multicast traffic to the backup link to minimize the communication interruption time.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    nqa test-instance admin-name test-name

    An NQA test instance is created and the test instance view is displayed.

  3. Run:

    test-type icmp

    The test type is set to ICMP.

  4. Run:

    destination-address ipv4 ipv4-address

    The destination IP address for the ICMP test instance is configured.

  5. Run:

    quit

    Return to the system view.

  6. Run:

    interface interface-type interface-number

    The upstream interface view is displayed.

  7. Run:

    igmp proxy track nqa admin-name test-name

    IGMP proxy is associated with the NQA test instance.

    By default, IGMP proxy on an interface is not associated with any NQA test instance.

    NOTE:
    The preceding procedure provides the basic configuration of an ICMP test instance. For details about NQA test instance configurations, see "NQA Configuration" in the Huawei AR Series Access Routers Configuration Guide - Network Management.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 17814

Downloads: 399

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next