No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Member Port

(Optional) Configuring a Static Member Port


A member port is connected to user hosts. The member ports can be learned by multicast protocol dynamically or configured manually. After Multicast Listener Discovery (MLD) snooping is enabled in a VLAN, all interfaces in the VLAN learn the multicast packets by default. When an interface receives an MLD Report message, the device sets the interface as a dynamic member port. A dynamic member port has an aging time.

If the user hosts connected to an interface need to receive the multicast packets destined for a specific multicast group or sent from a source to a group, add the interface to the multicast group or source group manually. This interface then becomes a static member port. The static member port will never age out.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    mld-snooping static-group group-ipv6-address [ source source-ipv6-address ] vlan vlan-id

    An interface is manually added to a multicast group.

Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20401

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next