No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

(Optional) Configuring the Range of Multicast Groups That an Interface Can Join


To limit the range of IPv6 multicast groups that an interface can join, configure ACL6 rules to filter received Multicast Listener Report messages so that the interface maintains multicast membership only in the allowed multicast groups.

Before specifying the range of multicast groups that an interface can join, configure an IPv6 access control list (ACL6) to define the range of multicast groups. For details about the ACL6 configuration, see "ACL Configuration" in the Huawei AR Series Access Routers Configuration Guide - Security.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    mld group-policy { acl6-number | acl6-name acl6-name } [ 1 | 2 ]

    The range of multicast groups that the interface can join is configured.

    By default, an interface can join any multicast group.


    When configuring an ACL6 rule for an interface, use the permit parameter in the rule command to allow hosts connected to the interface to join groups within the specified range. If no rule is configured in the ACL6, hosts connected to the interface cannot join any multicast groups.

Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21071

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next