No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing the PIM Status of the Specified Downstream Interfaces in IPv6 PIM Entries

Clearing the PIM Status of the Specified Downstream Interfaces in IPv6 PIM Entries

Context

You can clear the Join/Prune status and Assert status on the specified downstream interface in an IPv6 PIM entry. MLD status and static groups on this interface are not affected.

Clearing the PIM status of downstream interfaces may trigger the sending of Join/Prune packets, which affects multicast services.

Procedure

  • To clear the PIM status of specified downstream interfaces in specified IPv6 PIM entries, run the reset pim ipv6 routing-table group ipv6-group-address mask ipv6-group-mask-length source ipv6-source-address interface interface-type interface-number command in the user view.
Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20204

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next