No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
An MSDP Peer Is Always in Down State

An MSDP Peer Is Always in Down State

Fault Description

An MSDP peer is configured, but is always in Down state.

Fault Analysis

MSDP sets up a TCP connection between a local interface address and a remote MSDP peer.

  • If the local interface address is different from the MSDP peer address configured on a remote device, the TCP connection cannot be set up.
  • If two MSDP peers have no route to each other, the TCP connection cannot be set up.

Procedure

  1. Check whether the two devices that will be configured as MSDP peers learn ARP entries from each other.

    Run the display arp command to check whether two devices learn ARP entries from each other.

  2. Check whether there is a reachable unicast route between two devices that will be configured as MSDP peers.

    Run the display ip routing-table command to check whether there is a unicast route between the local MSDP peer and the remote MSDP peer.

  3. Check that the interface address of the MSDP peers is correct.

    Run the display current-configuration command to check whether the local interface address is the same as the address of the MSDP peer.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20472

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next