No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MLD Snooping Configuration

MLD Snooping Configuration

This chapter describes how to configure MLD snooping on a Layer 2 multicast device so that the device can resolve the MLD packets between the upstream Layer 3 device and downstream users. MLD snooping generates and maintains IPv6 Layer 2 multicast forwarding tables to distribute multicast data to only the receivers at the data link layer.


"Switch" mentioned in this chapter or shown in figures refer to routers with Layer 2 multicast functions.

Because MLD snooping is a Layer 2 multicast feature, all the MLD snooping configurations on interfaces mentioned in this chapter are performed on Layer 2 physical interfaces, including Eth-Trunk interfaces.

Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 36564

Downloads: 412

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next