No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


After the configurations of IGMP snooping policy are complete, run the following commands in any view to check the policy configurations and usage.


  • Run the display igmp-snooping [ vlan [ vlan-id ] ] configuration command to check the IGMP snooping configuration.

    The configurations of IGMP snooping include the configurations of IGMP snooping policy in the VLAN.

  • Run the display l2-multicast forwarding-table vlan vlan-id [ [ source-address source-address ] group-address { group-address | router-group } ] command to check the multicast forwarding table in a VLAN.

    You can check whether a Layer 2 multicast policy is used correctly by viewing Layer 2 multicast forwarding entries.

Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21338

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next