No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

Context

After configuring anycast rendezvous point (RP) in a Protocol Independent Multicast Sparse Mode (PIM-SM) domain, run the following commands in any view to check the brief and detailed information about MSDP peers and RP information about PIM routing entries.

Procedure

  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] brief command to check brief information about MSDP peers.
  • Run the display msdp [ vpn-instance vpn-instance-name | all-instance ] peer-status [ peer-address ] command to check the detailed information about MSDP peers.
  • Run the display pim [ vpn-instance vpn-instance-name | all-instance ] routing-table command to check RP information about PIM routing entries.
Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21739

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next