No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IGMP Snooping Entries

Clearing IGMP Snooping Entries

Context

IGMP snooping entries are classified into static and dynamic entries, and they are cleared in different ways.

Static entries cannot be restored after being cleared and can be created when you configure static member ports.

When dynamic entries in a forwarding table are cleared, the hosts in the VLAN do not receive the multicast packets temporarily. The hosts in the VLAN receive the multicast packets again only after the hosts send IGMP Report messages and the forwarding entries are regenerated on the router.

Procedure

  • Run the undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> } command in the interface view to remove the interface from a multicast group.

    You can run the following commands to batch remove the multicast group addresses that the interface joins.

    • undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-address2 vlan vlan-id
    • undo l2-multicast static-group [ source-address source-ip-address ] group-address all vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> }

  • Run the reset igmp-snooping group { all | vlan { all | vlan-id } } command in the user view to remove dynamic entries in a forwarding table.
Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21328

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next