No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deleting IPv6 Multicast Forwarding Entries and IPv6 Routing Entries

Deleting IPv6 Multicast Forwarding Entries and IPv6 Routing Entries

Context

After confirming that IPv6 multicast forwarding entries and IPv6 routing entries can be deleted, run the reset commands in the user view to delete the entries.

After you run the reset command to clear information in the IPv6 multicast forwarding table or in the IPv6 multicast routing table, multicast data cannot be normally transmitted. Exercise caution when you run this command.

Procedure

  • Run either of the following commands in the user view to delete entries from the IPv6 multicast forwarding table:

    • reset multicast ipv6 forwarding-table all

    • reset multicast ipv6 forwarding-table { ipv6-group-address [ ipv6-group-mask-length ] | ipv6-source-address [ ipv6-source-mask-length ] | incoming-interface { interface-type interface-number | register } } *

  • Run either of the following commands in the user view to delete entries from the IPv6 multicast routing table:

    • reset multicast ipv6 routing-table all

    • reset multicast ipv6 routing-table { ipv6-group-address [ ipv6-group-mask-length ] | ipv6-source-address [ ipv6-source-mask-length ] | incoming-interface { interface-type interface-number | register } } *

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21145

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next