No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

After configuring MD VPN, you can view the Share-Group and Multicast Tunnel Interface (MTI) information of a specified VPN instance to ensure that multicast VPN operates normally.


  • Run the display multicast-domain vpn-instance vpn-instance-name share-group [ local | remote ] command to check the Share-Group information of the MD for a specified VPN instance.
  • Run the display pim vpn-instance vpn-instance-name interface mtunnel interface-number [ verbose ] command to check information about the MTI.


Run the display multicast-domain vpn-instance command to view Share-Group and MTI information. For example:

<Huawei> display multicast-domain vpn-instance BLUE share-group
MD local share-group information for VPN-Instance: BLUE
  MTunnel address:
Info: There is no MD remote share-group information for VPN-Instance: BLUE
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20192

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next