No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Router Port

(Optional) Configuring a Static Router Port

Context

A router port is located on a Layer 2 device and connects to an upstream Layer 3 device (a multicast router or Layer 3 switch). When IGMP snooping is enabled in a VLAN, all interfaces in this VLAN learn forwarding entries from multicast protocol packets. When an interface receives IGMP Query messages or Protocol Independent Multicast (PIM) Hello messages, the Layer 2 device sets this interface as a dynamic router port. A router port provides the following functions:

  • Receives multicast data from the upstream device.
  • Forwards IGMP Report/Leave messages. IGMP Report/Leave messages received in a VLAN are forwarded only to router ports in the VLAN.

A dynamic router port has an aging time. If a dynamic router port does not receive an IGMP Query or a PIM Hello message before the aging time expires, the device deletes the port from the router port list. To enable an interface to forward IGMP Report/Leave messages to the upstream querier for a long time, configure the interface as a static router port.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. (Optional) Run:

    vlan vlan-id

    The VLAN view is displayed.

  3. (Optional) Run:

    undo igmp-snooping router-learning

    Dynamic router port learning is disabled.

    By default, dynamic router port learning is enabled in a VLAN.

  4. (Optional) Run:

    quit

    Exit from the VLAN view.

  5. Run:

    interface interface-type interface-number

    The interface view is displayed.

  6. Run:

    igmp-snooping static-router-port vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    An interface is configured as a static router port.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 19708

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next