No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MLD

Enabling MLD

Context

IPv6 multicast routing is the prerequisite for configuring all IPv6 multicast functions. You must enable IPv6 multicast routing before configuring an IPv6 multicast protocol.

Before configuring Multicast Listener Discovery (MLD) on a multicast router, enable MLD on an interface connected to receiver hosts.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    multicast ipv6 routing-enable

    IPv6 multicast routing is enabled.

  3. Run:

    interface interface-type interface-number

    The interface view is displayed.

  4. Run:

    mld enable

    MLD is enabled on the interface.

    By default, MLD is disabled on an interface.

    NOTE:

    If PIM (IPv6) and MLD need to be enabled on the same interface, enable PIM (IPv6) and MLD in sequence.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21524

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next