No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MSDP

Enabling MSDP


To enable all rendezvous points (RPs) on a network to share source information and to minimize the number of MSDP—enabled devices, it is recommended that you configure MSDP only on the RPs on the network.

After MSDP is enabled, the MSDP view is displayed. You can perform other MSDP configurations in the MSDP view. Enabling MSDP is the prerequisite for other MSDP configurations.


  1. Run:


    The system view is displayed.

  2. Run:

    msdp [ vpn-instance vpn-instance-name ]

    MSDP is enabled and the MSDP view is displayed.

Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20895

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next