No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv6 PIM Silent

Configuring IPv6 PIM Silent

Context

On the access layer, if the IPv6 PIM protocol is enabled on the interfaces directly connected to user hosts, the interfaces can establish PIM neighbor relationships to process various IPv6 PIM packets. The configuration, however, brings security risks. When a host maliciously sends many IPv6 PIM Hello messages, the device may break down.

To prevent the preceding case, set the state of the device interface to IPv6 PIM silent. An interface in IPv6 PIM silent state is disabled from receiving and forwarding any IPv6 PIM packet. All IPv6 PIM neighbors and IPv6 PIM state machines on the interface are deleted, and the interface immediately becomes a static designated router (DR). The IPv6 PIM silent function does not affect the Multicast Listener Discovery (MLD) function on the interface.

IPv6 PIM silent takes effect on an interface only when the interface is directly connected to a user network segment and when the network segment is connected only to this IPv6 PIM device.

After you configure IPv6 PIM silent on an interface, the interface no longer receives or sends any IPv6 PIM packets and other IPv6 PIM functions on the interface become invalid. Confirm your action before configuring this function.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    pim ipv6 silent

    The IPv6 PIM silent function is enabled.

Checking the Configuration

After IPv6 PIM silent is configured, you can check information about the IPv6 PIM interface.

  • Run the display pim ipv6 interface [ interface-type interface-number | up | down ] [ verbose ] command to check IPv6 PIM information on an interface.
Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21549

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next