No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Inter-AS Multicast Using Static RPF Peers

Inter-AS Multicast Using Static RPF Peers

As mentioned in RPF Rules of SA Messages, if an SA message is sent by an RPF peer, the message is accepted and forwarded to other MSDP peers. If you manually specify MSDP peers as static RPF peers to one another, these RPF peers accept SA messages without performing the RPF check.

Incorrect static RPF configurations may lead to loops of SA messages. Exercise caution when you configure static RPF peers. Static RPF peer relationships are usually set up among MSDP peers in multiple ASs.

Figure 6-8  Inter-AS multicast using static RPF peers

The configuration plan is as follows:
  1. Configure an MSDP peer relationship between RP1 and RP2.
  2. Configure RP1 and RP2 as static RPF peers of each other.
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 21515

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next