No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - IP Multicast

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the Frequency for Multicast Protocols to Send Trap Messages

Adjusting the Frequency for Multicast Protocols to Send Trap Messages


By adjusting the frequency for each multicast protocol to send trap messages, you can monitor the current statuses of various multicast protocol events.

Pre-configuration Tasks

Before adjusting the frequency for multicast protocols to send trap messages, complete the following tasks:

  • Configure basic Internet Group Management Protocol (IGMP) or Multicast Listener Discovery (MLD) functions.
  • Configure basic Protocol Independent Multicast (PIM) functions.
  • Enable the multicast trap function.
Updated: 2019-06-12

Document ID: EDOC1000097181

Views: 20380

Downloads: 401

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next