No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Log Reference

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document supports all the logs of device, including the parameters, meaning, possible causes and solution.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



OSPF/4/CONFLICT_ROUTERID_INTRA:OSPF Router id conflict is detected on intra-area. (ProcessId=[USHORT], RouterId=[IPADDR], AreaId=[IPADDR], NbrInterfaceIp1=[IPADDR], NbrInterfaceIp2=[IPADDR])


A router ID conflict was detected in an OSPF area.


Parameter Name Parameter Meaning
ProcessId Indicates the ID of a process.
RouterId Indicates the router ID of a router.
AreaId Indicates the ID of an area.
NbrInterfaceIp1 Indicates the IP address of the neighbor 's interface.
NbrInterfaceIp2 Indicates the IP address of the neighbor 's interface.

Possible Causes

At least two indirectly routers were configured with the same router ID, causing router LSAs to be constantly refreshed. As a result, route flapping occurs.


  1. Run the ospf router-id router-id command to change the router ID.
  2. End.
Updated: 2019-05-29

Document ID: EDOC1000097209

Views: 126267

Downloads: 188

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next