No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document supports all the logs of device, including the parameters, meaning, possible causes and solution.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RSVP/3/LOOP_RESV

RSVP/3/LOOP_RESV

Message

RSVP/3/LOOP_RESV:There is a loop in resv message (IngressLsrId=[IPADDR], TunnelId=[USHORT], EgressLsrId=[IPADDR]), the IP address [LoopAddress] conflicted with other router.

Description

A loop was found during the RSVP loop detection.

Parameters

Parameter Name Parameter Meaning
IngressLsrId Indicates the LSR ID of the ingress in the Resv message.
TunnelId Indicates the tunnel ID.
EgressLsrId Indicates the LSR ID of the egress in the Resv message.
[LoopAddress] Indicates the address that causes the loop.

Possible Causes

A loop was found during the RSVP loop detection because of incorrect configuration.

Procedure

  1. Run the display ip interface brief command on the involved device to check IP addresses of all interfaces and find the interfaces whose IP addresses are the same as that displayed in the LoopAddr field.
  2. Log in to the ingress based on the LSR ID displayed in the IngressLsrId field. Then run the display mpls te tunnel path command on the ingress to check nodes along the TE tunnel.
  3. Run the display ip interface brief command on each node to check the IP address and find the IP address the same as that displayed in the LoopAddr field.
  4. Change either of two identical IP addresses to be a different one.
  5. Collect log information and configuration information, and then contact technical support personnel.
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097209

Views: 85796

Downloads: 181

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next