Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RSVP/3/LOOP_RESV
Message
RSVP/3/LOOP_RESV:There is a loop in resv message (IngressLsrId=[IPADDR], TunnelId=[USHORT], EgressLsrId=[IPADDR]), the IP address [LoopAddress] conflicted with other router.
Parameters
Parameter Name | Parameter Meaning |
---|---|
IngressLsrId | Indicates the LSR ID of the ingress in the Resv message. |
TunnelId | Indicates the tunnel ID. |
EgressLsrId | Indicates the LSR ID of the egress in the Resv message. |
[LoopAddress] | Indicates the address that causes the loop. |
Procedure
- Run the display ip interface brief command on the involved device to check IP addresses of all interfaces and find the interfaces whose IP addresses are the same as that displayed in the LoopAddr field.
- Log in to the ingress based on the LSR ID displayed in the IngressLsrId field. Then run the display mpls te tunnel path command on the ingress to check nodes along the TE tunnel.
- Run the display ip interface brief command on each node to check the IP address and find the IP address the same as that displayed in the LoopAddr field.
- Change either of two identical IP addresses to be a different one.
- Collect log information and configuration information, and then contact technical support personnel.