No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document supports all the logs of device, including the parameters, meaning, possible causes and solution.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SEP/5/SEP_SET_PORT_DISCARD

SEP/5/SEP_SET_PORT_DISCARD

Message

SEP/5/SEP_SET_PORT_DISCARD:The port has been set to the discarding state. (SegmentID=[ULONG], InterfaceName=[STRING])

Description

An SEP ring port entered the Discarding state.

Parameters

Parameter Name Parameter Meaning
SegmentID ID of the SEP segment
InterfaceName Name of the interface added to the SEP segment

Possible Causes

Cause 1: A new link was added to the SEP segment.

Cause 2: An SEP segment port went Up or Down.

Procedure

  1. Check physical devices on the network to see whether a new SEP-enabled physical link is added.

    • If a new physical link has been added, go to Step 2.

    • If no new physical link has been added, go to Step 3.

  2. Check whether the added physical link is needed.

    • If the added physical link is needed, this trap message is informational only, and no action is required.

    • If the added physical link is not needed, go to Step 4.

  3. Check whether any port added to the SEP segment goes Up or Down.

    • If a port added to the SEP segment has gone Up or Down, this trap message is informational only, and no action is required.

    • If no port added to the SEP segment has gone Up or Down, go to Step 4.

  4. Collect trap, log, and configuration information, and contact technical support personnel.
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097209

Views: 91918

Downloads: 181

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next