No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document supports all the logs of device, including the parameters, meaning, possible causes and solution.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF/6/CONFLICT_ROUTERID_INTER

OSPF/6/CONFLICT_ROUTERID_INTER

Message

OSPF/6/CONFLICT_ROUTERID_INTER: OSPF Router id conflict maybe occur on inter-area. (ProcessId=[USHORT], RouterId=[IPADDR])

Description

The router IDs of OSPF devices in different areas might conflict because external routes were constantly refreshed.

Parameters

Parameter Name Parameter Meaning
ProcessId Indicates the ID of a process.
RouterId Indicates the ID of a router.

Possible Causes

The same router ID was configured for devices in different areas, causing route flapping.

This log is generated in the following scenarios:

  • Normal scenario: Device A generates a Type 5 LSA and floods it to Device B. Due to a fault, Device A restarts and reestablishes the neighbor relationship with Device B. Then, Device A receives the Type 5 LSA generated by itself from Device B. Because the router ID in the LSA conflicts with the local one, the log is generated. A large number of Type 5 LSAs may exist in the system. Therefore, this scenario is common. The log generated in this scenario requires no action.
  • Conflict scenario: The same router ID is configured for devices in different areas, causing route flapping.

Procedure

  1. Run the ospf router-id router-id command to change the router ID.
  2. End.
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097209

Views: 92720

Downloads: 181

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next