Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
WLAN/4/AP_FAULT_NOTIFY
Parameters
Parameter Name | Parameter Meaning |
---|---|
[STRING] |
Indicates the AP's fault information, in the following format: (APID=0, AP type=1DWA30A, AP name=ap-0) |
Possible Causes
1.
The AP was reset, the AP's factory settings were restored or the AP was upgraded automatically.
2.
The AP's subcard is loose.
Procedure
- Check whether the ap-reset or ap-manufacturer-config command has been used and identify whether AP was reset on AC.
- If so, go to step 2.
- If not, go to step 3.
- Wait until AP goes online, and a few minutes later check whether AP communication fault alarm is reported.
- If so, no action is required.
- If not, go to step 3.
- Check whether the AP's subcard is in the normal state.
Check whether the AP's indicator is green.
- If the indicator is green, the AP's subcard is in the normal state.
- If the indicator is in red, the AP's subcard is damaged or loose. Go to step 4.
- Contact technical support personnel.