No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

AR120, AR150, AR160, AR200, AR1200, AR2200, AR3200, and AR3600 V200R007

This document supports all the logs of device, including the parameters, meaning, possible causes and solution.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LLDP/4/BAD_PACKET

LLDP/4/BAD_PACKET

Message

LLDP/4/BAD_PACKET:[ULONG] invalid packets were received after latest notification. The last invalid packet came from interface [STRING].

Description

When a neighbor device is faulty, the format of an LLDP packet may be incorrect. As a result, the network management system (NMS) may not know the topology information. In this case, related information must be recorded and reported. The mechanism is as follows:

If an invalid packet is detected for the first time, an alarm is reported immediately and the invalid packet counter is set to 1.

In the following 30 seconds, if another invalid packet is received, 1 is added to the number of invalid packets.

30 seconds later, if another invalid packet is still received, an alarm containing the number of invalid packets and the port where this invalid packet is received is reported and the invalid packet counter is cleared to zero.

Parameters

Parameter Name Parameter Meaning
[PacketNumber] number of invalid packets
[InterfaceName] name of interface where invalid packets are received, for example, GigabitEthernet 1/0/0

Possible Causes

Reason 1:

The format of a received LLDP packet is invalid.

Reason 2:

An invalid packet is used for malicious attack.

Procedure

  1. The administrator can run a command to check whether the neighbor device connected to the port where an invalid packet is received is in the normal status.

    • In the system view, run display interface to check whether the status of the port is UP.
    • If both the local device and the neighbor device enable LLDP, run display lldp local to check whether the link status is UP.

    1) If yes, go to step 3.

    2) If no, go to step 2.

  2. Check whether the connection cable is connected properly.

    1) If no, connect the cable properly and go to step 4.

    2) If yes, go to step 3.

  3. Check whether there are invalid connections.

    1) If yes, remove the cables and go to step 4.

    2) If no, go to step 5.

  4. 30 seconds later, check whether this log still exists in the log buffer.

    1) If yes, go to step 5.

    2) If no, go to step 6.

  5. Collect log information and configuration information, and then contact technical support personnel.
  6. End.
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097209

Views: 85975

Downloads: 181

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next