No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Type for a Port

Setting the Link Type for a Port

Context

P2P links can implement rapid convergence. If the two ports connected by a P2P link are root or designated ports, they can transit to the Forwarding state quickly by sending Proposal and Agreement packets. This reduces the forwarding delay.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of an Ethernet interface participating in STP calculation is displayed.

  3. Run:

    stp point-to-point { auto | force-false | force-true }

    The link type is set for the interface.

    By default, an interface automatically identifies whether it is connected to a P2P link. P2P links implement rapid network convergence.

    • If the Ethernet interface works in full-duplex mode, the interface is connected to a P2P link. In this case, force-true can be specified in the command to implement rapid network convergence.

    • If the Ethernet interface works in half-duplex mode, you can run the stp point-to-point force-true command to forcibly set the link type to P2P.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 9289

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next