No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the MSTP Protocol Packet Format on an Interface

Configuring the MSTP Protocol Packet Format on an Interface

Context

MSTP protocol packets have two formats: dot1s (IEEE 802.1s standard packets) and legacy (proprietary protocol packets).

You can specify the packet format and use the auto mode. In auto mode, the switching device switches the MSTP protocol packet format based on the received MSTP protocol packet format so that the switching device can communicate with the peer device.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The Ethernet interface view is displayed.

  3. Run:

    stp compliance { auto | dot1s | legacy }

    The MSTP protocol packet format is configured on the interface.

    The auto mode is used by default.

    NOTE:

    The negotiation will fail if the format of MSTP packets is set to dot1s at one end and legacy at the other end.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20225

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next