No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Introduction to GVRP

Introduction to GVRP

Definition

The Generic Attribute Registration Protocol (GARP) provides a mechanism to propagate attributes so that a protocol entity can register and deregister attributes. By filling different attributes into GARP packets, GARP supports different upper-layer applications.

The Generic Attribute Registration Protocol (GVRP) is used to register and deregister VLAN attributes.

GARP identifies applications through destination MAC addresses. IEEE Std 802.1Q assigns 01-80-C2-00-00-21 to the VLAN application (GVRP).

Purpose

To deploy certain VLANs on all devices on a network, the network administrator needs to manually create these VLANs on each device. As shown in Figure 10-1, three routers are connected through trunk links. VLAN 2 is configured on Router A, and VLAN 1 is configured on Router B and Router C. To forward packets of VLAN 2 from Router A to Router C, the network administrator must manually create VLAN 2 on Router B and Router C.

Figure 10-1  Networking of GVRP application

When a network is complicated and the network administrator is unfamiliar with the network topology or when many VLANs are configured on the network, huge workload is required for manual configuration. In addition, configuration errors may occur. In this case, you can configure GVRP on the network to implement automatic registration of VLANs.

Benefits

GVRP is based on GARP and is used to maintain VLAN attributes dynamically on devices. Through GVRP, VLAN attributes of one device can be propagated throughout the entire switching network. GVRP enables network devices to dynamically deliver, register, and propagate VLAN attributes, reducing workload of the network administrator and ensuring correct configuration.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20318

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next