No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Notes

Configuration Notes

Network Element Involved

None

License Support

VLAN is a basic feature of a router and is not under license control.

Feature Dependencies and Limitations

  • You are advised to plan service and management VLANs so that any broadcast storms in service VLANs do not affect device management.
  • In practice, specify VLANs from which packets need to be transparently transmitted by a trunk interface. Do not use the port trunk allow-pass vlan all command if possible.
  • All interfaces join VLAN 1 by default. When unknown unicast, multicast, or broadcast packets of VLAN 1 exist on the network, broadcast storms may occur. When VLAN 1 is used, pay attention to the following points:
    • Remove the interfaces that do not need to join VLAN 1 from VLAN 1 to prevent loops.
    • You are advised to remove interfaces from VLAN 1 in Eth-Trunk or ring networking.
    • When connecting to an access device, to prevent broadcast storms in VLAN 1, do not configure the uplink interface of the access device to transparently transmit packets from VLAN 1.
NOTE:

AR502G-L-D-H and AR502GR-L-D-H do not support VLAN technology.

AR510 series do not support VLAN technology.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 17441

Downloads: 63

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next