No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VXLAN

Configuring VXLAN


The VLAN technology used to divide virtual networks cannot provide sufficient VLAN isolation domains when the data volume increases rapidly. In addition, VMs can only work at Layer 2 on VLAN networks and VLAN configuration must be completed in advance. To solve these problems, you can configure VXLAN to implement isolation on a large Layer 2 network and use UDP tunnels to enable VMs to communicate at Layer 3.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    vxlan vni vni-id

    A VNI view is created and the VNI view is displayed.

    By default, no VNI is created.

  4. Run:

    vxlan source ip-address

    An IP address is configured for the source VTEP.

    By default, no IP address is configured for the source VTEP.

  5. Run:

    vxlan peer ip-address

    An IP address is configured for the peer VTEP.

    By default, no IP address is configured for the peer VTEP.

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 19733

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next