No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Traffic Policy to Implement Inter-VLAN Layer 3 Isolation

Configuring a Traffic Policy to Implement Inter-VLAN Layer 3 Isolation

Context

After inter-VLAN Layer 3 connectivity is configured, if some users in different VLANs require unidirectional access or need to be isolated, configure inter-VLAN Layer 3 isolation.

Inter-VLAN Layer 3 isolation is implemented using a traffic policy. A traffic policy is configured by binding traffic classifiers to traffic behaviors. The router classifies packets according to IP addresses or other information in packets, and associates a traffic classifier with a traffic behavior to reject the packets matching the traffic classifier, implementing inter-VLAN Layer 3 isolation.

Router provides inter-VLAN Layer 3 isolation based on MQC and based on the simplified ACL-based traffic policy. You can select one of them according to your needs.

Pre-configuration Tasks

Before configuring a traffic policy to implement inter-VLAN Layer 3 isolation, complete the following task:

Procedure

  • Configure MQC to implement inter-VLAN Layer 3 isolation.

    Perform the following MQC configurations to implement inter-VLAN Layer 3 isolation:
    • Specify permit or deny in the traffic behavior.
    • Apply the traffic policy to a VLAN or an interface that allows the VLAN.

    For details about how to configure MQC, see Configuring Packet Filtering in Huawei AR Series IOT Gateway Configuration Guide - QoS.

  • Configure a simplified ACL-based traffic policy to implement inter-VLAN Layer 3 isolation.

    For details about how to configure a simplified ACL-based traffic policy, see Configuring ACL-based Packet Filtering in Huawei AR Series IOT Gateway Configuration Guide - QoS.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 8223

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next