No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Remote Bridging

Remote Bridging

If LANs in different geographical locations need to communicate with each other at the link layer, remote bridging can be used to bridge the LANs.

Figure 15-6  Networking diagram for remote bridging

As shown in Figure 15-6, Router A and Router B are connected with each other over a network. PC2, PC4, PC5, and PC7 belong to four different LANs (LAN 2, LAN 1, LAN 4, LAN 3) on different network segments. LAN 1 needs to communicate with LAN 3, and LAN 2 with LAN 4.

Bridges 1 and 2 are created on Router A and Router B, respectively.Ethernet2/0/1 and Serial 1/0/0 on both Router A and Router B are added to bridge 1; Ethernet2/0/2 and Serial 1/0/1 on both Router A and Router B are added to bridge 2. In this manner, the preceding communication requirement can be met.

Other types of links, such as Ethernet, Point-to-Point Protocol (PPP), Asynchronous Transfer Mode (ATM), can also be used for remote bridging.

To support remote bridging, transparent bridging provides the following functions:

  • Allow Ethernet interfaces, Ethernet sub-interfaces, VLANIF, Serial, Serial sub-interfaces, VT, Dialer interfaces to be added to bridge groups.

  • Link encapsulation protocols such as Ethernet, PPP, PPPoA, PPPoE and PPPoEoA.

  • 802.1Q VLAN ID transparent transmission.

  • Bridging IP and non-IP packets.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 11613

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next