No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the STP Timers

Setting the STP Timers

Context

The following timers are used in spanning tree calculation:
  • Forward Delay: specifies the delay before a state transition. After the topology of a ring network changes, it takes some time to spread the new configuration BPDU throughout the entire network. As a result, the original blocked port may be unblocked before a new port is blocked. When this occurs, a loop exists on the network. You can set the Forward Delay timer to prevent loops. When the topology changes, all ports will be temporarily blocked during the Forward Delay.
  • Hello Time: specifies the interval at which hello packets are sent. A switching device sends configuration BPDUs at the specified interval to detect link failures. If the switching device does not receive any BPDUs within an interval of Hello Time, the switching device recalculates the spanning tree.
  • Max Age: determines whether BPDUs expire. A switching device determines that a received configuration BPDU times out when the Max Age expires.

Devices on a ring network must use the same values of Forward Delay, Hello Time, and Max Age.

You are not advised to directly change the preceding three timers. The three parameters are relevant to the network scale; therefore, it is recommended that you set the network diameter so that the spanning tree protocol automatically adjusts these timers. When the default network diameter is used, the three timers also retain their default values.

To prevent frequent network flapping, make sure that the Hello Time, Forward Delay, and Max Age timer values conform to the following formulas:

  • 2 x (Forward Delay - 1.0 second) >= Max Age

  • Max Age >= 2 x (Hello Time + 1.0 second)

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Set the Forward Delay, Hello Time, and Max Age timers.
    1. Run:

      stp timer forward-delay forward-delay

      The Forward Delay timer is set for the switching device.

      By default, the Forward Delay timer is 1500 centiseconds (15 seconds).

    2. Run:

      stp timer hello hello-time

      The Hello Time is set for the switching device.

      By default, the Hello Time is 200 centiseconds (2 seconds).

    3. Run:

      stp timer max-age max-age

      The Max Age timer is set for the switching device.

      By default, the Max Age timer is 2000 centiseconds (20 seconds).

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 17371

Downloads: 63

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next