No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

Table 13-9 lists the configuration task summary of SEP.

Table 13-9  Configuration task summary of SEP
Item Description Task

Configuring Basic SEP Functions

After basic SEP functions are configured on devices, the devices start SEP negotiation. One of the two interfaces that complete neighbor negotiations last is blocked to eliminate redundant links.

When logging in to nodes on a SEP semi-ring through Telnet to configure the nodes, note the following points:
  • Basic SEP functions need to be configured from the node at one end of the semi-ring to the node at the other end of the semi-ring.

Configuring Basic SEP Functions

Specifying an Interface to Block

In some cases, however, the negotiated blocked interface may not be the required one. You can specify an interface to block according to network requirements.

Specifying an Interface to Block

Configuring SEP Multi-Instance

To implement load balancing and make efficient use of bandwidth, protected instances need to be deployed on a SEP network and mapped to VLANs.

Configuring SEP Multi-Instance

Configuring the Topology Change Notification Function

A SEP network usually needs to work together with another network running other features. To ensure network reliability, if the topology of one network changes, the other network must be able to detect the topology change and take measures to ensure reliable data transmission. Therefore, the topology change notification function needs to be enabled on the SEP network.

Configuring the Topology Change Notification Function

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 19475

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next