No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Proxy ARP on the VLANIF Interface Corresponding to a Super-VLAN

(Optional) Enabling Proxy ARP on the VLANIF Interface Corresponding to a Super-VLAN

Context

VLAN aggregation allows sub-VLANs to use the same subnet address, but prevents PCs in different sub-VLANs from communicating with each other at the network layer.

PCs in common VLANs can communicate with each other at the network layer using different gateway addresses. VLAN aggregation enables PCs in a super-VLAN to use the same subnet address and gateway address. Because PCs in different sub-VLANs belong to one subnet, they communicate with each other only at Layer 2 but not Layer 3. These PCs are isolated from each other at Layer 2. Consequently, PCs in different sub-VLANs cannot communicate with each other.

Proxy ARP is required to enable PCs in a sub-VLAN to communicate with PCs in another sub-VLAN or PCs on other networks. After a super-VLAN and its VLANIF interface are created, proxy ARP must be enabled to allow the super-VLAN to forward or process ARP Request and Reply packets. Proxy ARP allows PCs in sub-VLANs to communicate with each other at the network layer.

NOTE:

After proxy ARP is enabled on the VLANIF interface corresponding to a super-VLAN, hosts in all sub-VLANs of the super-VLAN can communicate.

VLAN aggregation simplifies configurations for the network where many VLANs are configured and PCs in different VLANs need to communicate with each other.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface vlanif vlan-id

    The view of the VLANIF interface corresponding to the super-VLAN is displayed.

  3. Run:

    arp-proxy inter-sub-vlan-proxy enable

    Proxy ARP is enabled between sub-VLANs.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 11434

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next