No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Local Interfaces to a Bridge Group

Adding Local Interfaces to a Bridge Group

Context

A bridge group is a virtual group. It can forward packets only after interfaces have been added to the group.

As shown in Figure 15-15, the following methods can be used to add users to a bridge group:
  • Directly add users to the bridge group. User 3 uses this method.
  • Use a VLAN to add users to the bridge group. Create a VLAN on a bridge and add users to the VLAN. Users then connect to the bridge group through the VLANIF interface. User 1 and User 2 use this method.
  • Use Ethernet sub-interfaces to add users to the bridge group. This method is used when flows on a physical interface need to be differentiated using sub-interfaces. User 4 uses this method.
Figure 15-15  Networking diagram for adding users to bridge groups

Perform the following steps on the user-side interface of the device.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The user-side interface view is displayed.

  3. Run:

    bridge bridge-id

    An interface is added to a bridge group.

    The number of interfaces that can be added to a bridge group depends on device models:
    • AR510: 10
    • AR500&AR530&AR550&AR2500: 20
    Interfaces of different types can be added to the same bridge group, but Layer 2 interfaces cannot be added to a bridge group.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 19319

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next