No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Traffic Is Unevenly Load Balanced Among Eth-Trunk Member Interfaces Because the Load Balancing Mode Is Incorrect

Traffic Is Unevenly Load Balanced Among Eth-Trunk Member Interfaces Because the Load Balancing Mode Is Incorrect

Fault Description

Traffic is unevenly load balanced among Eth-Trunk member interfaces due to the incorrect load balancing mode.

Procedure

  1. Run the display eth-trunk command to check whether the load balancing mode of the Eth-Trunk meets networking requirements. For example, source or destination IP address-based load balancing is not recommended in Layer 2 networking.

  2. Run the load-balance command to set an appropriate load balancing mode.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 19853

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next