No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MSTP Background

MSTP Background

RSTP, an enhancement to STP, implements fast convergence of the network topology. There is a defect for both RSTP and STP: All VLANs on a LAN use one spanning tree, and VLAN-based load balancing cannot be performed. Once a link is blocked, it will no longer transmit traffic, wasting bandwidth and causing the failure in forwarding certain VLAN packets.

Figure 12-1  STP/RSTP defect

On the network shown in Figure 12-1, STP or RSTP is enabled. The broken line shows the spanning tree. S6 is the root switching device. The links between S1 and S4 and between S2 and S5 are blocked. VLAN packets are transmitted by using the corresponding links marked with "VLAN2" or "VLAN3."

Host A and Host B belong to VLAN 2 but they cannot communicate with each other because the link between S2 and S5 is blocked and the link between S3 and S6 denies packets from VLAN 2.

To fix the defect of STP and RSTP, the IEEE released 802.1s in 2002, defining the Multiple Spanning Tree Protocol (MSTP). MSTP implements fast convergence and provides multiple paths to load balance VLAN traffic.

MSTP divides a switching network into multiple regions, each of which has multiple spanning trees that are independent of each other. Each spanning tree is called a Multiple Spanning Tree Instance (MSTI) and each region is call a Multiple Spanning Tree (MST) region.

NOTE:

An instance is a collection of VLANs. Binding multiple VLANs to an instance saves communication costs and reduces resource usage. The topology of each MSTI is calculated independent of one another, and traffic can be balanced among MSTIs. Multiple VLANs that have the same topology can be mapped to one instance. The forwarding status of the VLANs for a port is determined by the port status in the MSTI.

Figure 12-2  Multiple spanning trees in an MST region

As shown in Figure 12-2, MSTP maps VLANs to MSTIs in the VLAN mapping table. Each VLAN can be mapped to only one MSTI. This means that traffic of a VLAN can be transmitted in only one MSTI. An MSTI, however, can correspond to multiple VLANs.

Two spanning trees are calculated:
  • MSTI 1 uses S4 as the root switching device to forward packets of VLAN 2.
  • MSTI 2 uses S6 as the root switching device to forward packets of VLAN 3.

In this manner, devices within the same VLAN can communicate with each other; packets of different VLANs are load balanced along different paths.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20099

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next