No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Parameters for Interoperation Between Huawei and Non-Huawei Devices

Setting Parameters for Interoperation Between Huawei and Non-Huawei Devices

To implement interoperation between Huawei and non-Huawei devices, select the fast transition mode based on the Proposal/Agreement mechanism of the non-Huawei device.

Context

A switching device supports the following Proposal/Agreement modes:

  • Enhanced mode: The device determines the root port when it calculates the synchronization flag bit.
    1. An upstream device sends a Proposal message to a downstream device to request fast state transition. After receiving the message, the downstream device sets the port connected to the upstream device as the root port and blocks all non-edge ports.

    2. The upstream device sends an Agreement message to the downstream device. After the downstream device receives the message, the root port transitions to the Forwarding state.

    3. The downstream device responds with an Agreement message. After receiving the message, the upstream device sets the port connected to the downstream device as the designated port, and then the designated port transitions to the Forwarding state.

  • Common mode: The device ignores the root port when it calculates the synchronization flag bit.
    1. An upstream device sends a Proposal message to a downstream device to request fast state transition. After receiving the message, the downstream device sets the port connected to the upstream device as the root port and blocks all non-edge ports. Then, the root port transitions to the Forwarding state.

    2. The downstream device responds with an Agreement message. After receiving the message, the upstream device sets the port connected to the downstream device as the designated port, and then the designated port transitions to the Forwarding state.

On an STP network, if a Huawei switching device is connected to a non-Huawei device that uses a different Proposal/Agreement mechanism, the two devices may fail to interoperate with each other. Select the enhanced mode or common mode based on the Proposal/Agreement mechanism of the non-Huawei device.

Pre-configuration Tasks

Before setting parameters for interoperation between Huawei and non-Huawei devices, configure basic STP/RSTP functions.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of an interface participating in spanning tree calculation is displayed.

  3. Run:

    stp no-agreement-check

    The common fast transition mode is specified.

    By default, the enhanced fast transition mode is used on a port.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 19901

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next