No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Dynamic MAC Address Entries

Setting the Aging Time of Dynamic MAC Address Entries

Context

To prevent explosive increase of MAC address entries, set the aging time for dynamic MAC address entries.

Because the network topology changes frequently, the industrial switch router will learn more and more MAC addresses. Therefore, the aging time needs to be set properly for dynamic MAC address entries so that the industrial switch router can delete unneeded MAC address entries to prevent a sharp increase of MAC address entries. A shorter aging time makes the industrial switch router more sensitive to network changes and is applicable to networks where network topology changes frequently. A longer aging time makes the industrial switch router more insensitive to network changes and is only applicable to stable networks.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    mac-address aging-time aging-time

    The aging time is set for dynamic MAC address entries.

Checking the Configuration

Run the display mac-address aging-time command to view the aging time of dynamic MAC address entries.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 9410

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next