No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Notes

Configuration Notes

This section describes the product models that support VLAN termination and notes about configuring VLAN termination.

Network Element Involved


License Support

VLAN termination is a basic feature of a router and is not under license control.

Feature Dependency and Limitation

  • Termination sub-interfaces cannot be configured on an Eth-Trunk member interface.
  • You are advised to add member interfaces to an Eth-Trunk and configure termination sub-interfaces on the Eth-Trunk in sequence. Termination sub-interfaces can be configured successfully on an Eth-Trunk only when all series of cards where member interfaces reside support termination sub-interfaces.
  • The VLAN IDs terminated by a sub-interface cannot be created in the system view or be displayed using a display command.
  • When VLAN IDs terminated by a sub-interface are used for Layer 3 forwarding, only the first VLAN takes effect even if multiple inner VLAN IDs are specified.
  • The VLAN terminated by a sub-interface cannot be configured as a super-VLAN or sub-VLANs.
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20923

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next