No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the LACP Mode

Setting the LACP Mode

Context

Link aggregation can work in manual load balancing mode or LACP mode depending on whether LACP is used.

In LACP mode, you must manually create an Eth-Trunk and add interfaces to the Eth-Trunk. However, LACP determines active interfaces through negotiation.

When an Eth-Trunk changes from manual load balancing mode to LACP mode, the Eth-Trunk can contain member interfaces. When an Eth-Trunk changes from LACP mode to manual load balancing mode, ensure that the Eth-Trunk has no member interface.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

  3. Run:

    mode lacp-static

    A working mode of the Eth-Trunk is configured.

    By default, an Eth-Trunk works in manual load balancing mode.

    Before configuring an Eth-Trunk, ensure that both ends use the same working mode. If the local end works in LACP mode, the remote end must use the LACP mode.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 8230

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next