No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Registration Mode for a GVRP Interface

(Optional) Setting the Registration Mode for a GVRP Interface

Context

A GVRP interface supports three registration modes:
  • Normal: In this mode, the GVRP interface can dynamically register and deregister VLANs, and transmit dynamic VLAN registration information and static VLAN registration information.
  • Fixed: In this mode, the GVRP interface is disabled from dynamically registering and deregistering VLANs and can transmit only the static VLAN registration information. If the registration mode is set to fixed for a trunk interface, the interface allows only the manually configured VLANs to pass even if it is configured to allow all the VLANs to pass.
  • Forbidden: In this mode, the GVRP interface is disabled from dynamically registering and deregistering VLANs and can transmit only information about VLAN 1. If the registration mode is set to forbidden for a trunk interface, the interface allows only VLAN 1 to pass even if it is configured to allow all the VLANs to pass.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    gvrp registration { fixed | forbidden | normal }

    The registration mode is set for the interface.

    By default, the registration mode of a GVRP interface is normal.

    NOTE:

    Before setting the registration mode for an interface, enable GVRP on the interface.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20739

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next