No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

Table 12-8 lists the configuration task summary of MSTP.

Table 12-8  Configuration task summary of MSTP
Item Description Task

Configuring Basic MSTP Functions

MSTP is commonly configured on switching devices to trim a ring network to a loop-free network. Devices start spanning tree calculation after the working mode is set and MSTP is enabled. Use any of the following methods if you need to intervene in the spanning tree calculation:
  • Manually configure the root bridge and secondary root bridge
  • Set a priority for a switching device in an MSTI
  • Set a path cost for a port in an MSTI
  • Set a priority for a port in an MSTI

Configuring Basic MSTP Functions

Configuring MSTP Parameters on an Interface

Proper MSTP parameter settings achieve rapid convergence.

Configuring MSTP Parameters on an Interface

Configuring MSTP Protection Functions

This section describes how to configure MSTP protection functions. You can configure one or more functions.

Configuring MSTP Protection Functions

Configuring MSTP Interoperability Between Huawei Devices and Non-Huawei Devices

To communicate with a non-Huawei device, set proper parameters on the MSTP-enabled Huawei device.

Configuring MSTP Interoperability Between Huawei Devices and Non-Huawei Devices

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20620

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next