No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings

Default Settings

This section describes default parameter settings of link aggregation.

Table 2-3  Default parameter settings of link aggregation

Parameter

Value

Link aggregation mode

Manual load balancing mode

Upper threshold for the number of active member links

8

Lower threshold for the number of active member links

1

LACP system priority

32768

LACP interface priority

32768

LACP preemption

Disabled

LACP preemption delay

30s

Timeout interval at which LACPDUs are received

90s

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 8163

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next