No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Environment

Application Environment

This section describes the applicable environment of MAC address flapping.

MAC Address Flapping Detection

As shown in Figure 1-6, a loop occurs on a user network because network cables between two LSWs are incorrectly connected. The loop causes MAC address flapping and MAC address table flapping.

You can enable MAC address flapping detection on the Router to detect MAC address flapping and discover loops.

Figure 1-6  Networking diagram of MAC address flapping detection

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 17079

Downloads: 63

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next