No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Introduction to Link Aggregation

Introduction to Link Aggregation

This section describes definition and purpose of link aggregation.

Definition

Ethernet link aggregation, also called Eth-Trunk, bundles multiple physical links to form a logical link to increase link bandwidth. The bundled links back up each other, increasing reliability.

Purpose

As the network scale expands increasingly, users propose increasingly high requirements on Ethernet backbone network bandwidth and reliability. Originally, to increase the bandwidth, users use high-speed cards or devices supporting high-speed interface cards to replace old interface cards or devices. This solution, however, is costly and inflexible.

Link aggregation helps increase bandwidth by bundling a group of physical interfaces into a single logical interface, without having to upgrade hardware. In addition, link aggregation provides link backup mechanisms, greatly improving link reliability.

Link aggregation has the following advantages:

  • Increased bandwidth

    The bandwidth of the link aggregation interface is the sum of bandwidth of member interfaces.

  • Higher reliability

    When an active link fails, traffic on this active link is switched to another active link, improving reliability of the link aggregation interface.

  • Load balancing

    In a link aggregation group (LAG), traffic is load balanced among active links of member interfaces.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 17460

Downloads: 63

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next