No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


GVRP enables routers on a network to dynamically maintain and update VLAN information. With GVRP, you can adjust the VLAN deployment on the entire network by configuring only a few devices. You do not need to analyze the topology and manage configurations. As shown in Figure 10-9, GVRP is enabled on all devices. Devices are interconnected through trunk ports and each trunk port allows packets of all VLANs to pass. You simply need to configure static VLANs 100 to 1000 on RouterA and RouterC. Then the other devices can learn VLANs 100 to 1000 through GVRP.

Figure 10-9  Typical application of GVRP

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20629

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next