No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Environment

Application Environment

This section describes the applicable environment of MSTP.

Application of MSTP

Figure 12-11  Networking diagram for a typical MSTP application

MSTP allows packets in different VLANs to be forwarded by using different spanning tree instances, as shown in Figure 12-11. The configurations are as follows:

  • All devices on the network belong to the same MST region.

  • VLAN 10 packets are forwarded within MSTI 1; VLAN 30 packets are forwarded within MSTI 3; VLAN 40 packets are forwarded within MSTI 4; VLAN 20 packets are forwarded within MSTI 0.

In Figure 12-11, S1 and S2 are devices at the aggregation layer; S3 and S4 are devices at the access layer. Traffic from VLAN 10 and VLAN 30 is terminated by aggregation devices, and traffic from VLAN 40 is terminated by the access device. Therefore, S1 and S2 can be configured as the roots of MSTI 1 and MSTI 3, and S3 can be configured as the root of MSTI 4.

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20217

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next