No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling GVRP

Enabling GVRP

Context

Before enabling GVRP on an interface, you must enable GVRP globally. GVRP can be enabled only on trunk interfaces. You must perform related configurations to ensure that all dynamically registered VLANs can pass the trunk interfaces.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    gvrp

    GVRP is enabled globally.

  3. Run:

    interface interface-type interface-number

    The interface view is displayed.

  4. Run:

    port link-type trunk

    The link type of the interface is set to trunk.

  5. Run:

    port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

    The interface is added to the specified VLANs.

  6. Run:

    gvrp

    GVRP is enabled on the interface.

    By default, GVRP is disabled globally and on each interface.

    NOTE:

    The device supports a maximum of 256 dynamic VLANs when using default GARP timers. When the recommended GARP timer settings are used, the device supports a maximum of 4094 dynamic VLANs.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20154

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next