No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switching to the RSTP Mode

Switching to the RSTP Mode

Context

If an interface on an RSTP-enabled device is connected to an STP-enabled device, the interface switches to the STP compatible mode.

If the STP-enabled device is powered off or removed, the interface cannot automatically switch to the RSTP mode. When the interface goes Up again, the interface needs to be manually switched to the RSTP mode.

If the STP-enabled switching device is switched to the RSTP mode, the interface can automatically switch to the RSTP mode.

Procedure

  • Switching to the RSTP mode in the interface view
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The view of an interface participating in spanning tree calculation is displayed.

    3. Run:

      stp mcheck

      The interface is switched to the RSTP mode.

  • Switching to the RSTP mode in the system view
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      stp mcheck

      The device is switched to the RSTP mode.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 8286

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next